Bridgeport WV Heating, AC Repair & Plumber

Found wires for humidifier cut need to contact skuttle for replacement parts

Gas valve selonoid was not staying open, replaced gas valve, ok at this time.

Performed platinum maintenance check, no issues at this time.

Replaced blower wheel

Found water in inducer motor drip leg clear and system heating properly at this time.

At this time, ac is reading proper temperature and pressure with current ambient temperature.

Unit pressure switch was not closing, found trap to be plugged, as well as connection on one of pressure switch hoses. Cleared both, ran combustion analysis, ok at this time.

Replace Primary & Secondary Heat Exchanger

Cody replaced all 3 pressure switches, I replaced controlboard and ran new wire, unit is coming on at this time

Replaced inducer motor before failure. Older part had failing internal barring and made bad squill. System operating properly at this time.

Replaced filters on last visit due to high limit error, unit was off on high limit again, found blower motor belt loose, tightened belt, ok at this time.

Mini split was low on charge, added .5 lb 410a, heating ok at this time, will need to verify pressure in spring during warranty check. Renewing labor warranty agreement that expires 1/10/20

Inducer motor failing ordered replacement quoted level 6

Mini split system operating properly no problem found

Found furnace insulation pulled into blower wheel, removed, cycled, ok at this time.

Main room unit off on high limit, replaced filters, ok at this time. Trane unit disconnect needs replaced, not connecting properly. Customer will have power coming in corrected and contact if there are any issues after.

Need to schedule to add sensor to ecobee 3

Blower wheel unbalanced ordered

Includes pad, disconnect box with conduit whip, flush of lineset, condensate pump, furnace switch, and all miscellaneous materials and labor to completely install. We will adapt to the existing flue pipes, gas line, high/low voltage wiring, and duct system. For Furnace Only: $2,998.00

Includes pad, disconnect box with conduit whip, flush of lineset, condensate pump, furnace switch, and all miscellaneous materials and labor to completely install. We will adapt to the existing flue pipes, gas line, high/low voltage wiring, and duct system. For Furnace Only: $2,998.00

Includes pad, disconnect box with conduit whip, flush of lineset, condensate pump, furnace switch, and all miscellaneous materials and labor to completely install. We will adapt to the existing flue pipes, gas line, high/low voltage wiring, and duct system. For Furnace Only: $2,998.00

Includes pad, disconnect box with conduit whip, flush of lineset, condensate pump, furnace switch, and all miscellaneous materials and labor to completely install. We will adapt to the existing flue pipes, gas line, high/low voltage wiring, and duct system. For Furnace Only: $2,998.00

Replaced inducer motor, under warranty. Ok at this time.

Arrived and found no issue with system. Reset and system fired off and is operating properly at this time. Issue seemed to occur with first start up of furnace. May have been air in lines at the time. No fault codes were flashing.

Have to order control board. Tapped relay, started working, but will not continue to work.