Lost Creek WV Heating, AC Repair & Plumber

Service Call Platinum Client furnace operating when I arrived cycled system several times unable to get any issue, inlet gas pressure 14 inH20, outlet 3.3 , 55 degree rise, clean filter, checked thermostat system operating normally. unable to light water heater, believe control is failed, attached picture of control and water heater model, customer will be calling to schedule plumber.

CLEAN EVAPORATOR COIL - 1-5 Ton, Chemical In Place * STANDARD * ALSO CONSIDER Filters

Service Call Platinum Client furnace operating when I arrived, cycled system several times with no error, i did find pressure switch port on inducer partially blocked, cleared port, system has a 55 degree temperature rise, system operating normally, I did show customer where to find control board led, I informed him that if this happens again when it does to take note of code to help track down issue.

Service Call Platinum Client did nit find issue with system cycled it a few times furnace ran for approximately 30 minutes temp rise approximately 51 all combustion number met all parameters however gas valve did seem lazy but no issues appears concerning with part do recommend getting added to service plan and did quote customer did have solid door infront of furnace blocking combustion air. furnace is 80% so it does not have fresh air intake did instruct customer to leave door off if possible.

Service Call Platinum Client 10+ year old Goodman package unit, inducer motor failure, was able to hand spin inducer to get system operating, informed customer this isn't a permanent fix and motor will need to be replaced along with repairing flex duct that is pinched off and open allowing system to draw crawl space air, ran combustion analysis, 270 ppm advised customer of elevated CO levels and recommended maintenance on system if they chose to go with repair, got customer estimate for new system and quoted repair.

Did preform heating check on system did find the gas pressures to be 4.0 in wc did adjust them to 3.45 ( in accordance to carrier system specifications)

Service Call Platinum Client Compressor wasn't kicking on, found capacitor failed replaced capacitor, checked refrigerant levels, the system has 20-degree temperature drop and filter is good, system operating normally. The system is older advice looking into a replacement.

-Comfort Club Membership Tune-Up on Cooling System -replaced filter -cleaned filter on dehumidifier.

performed combustion analysis, checked temperature rise, checked gas pressure

HVAC SERVICE

HVAC Service

Oldest AC Contest

Performed Platinum Comfort Club Membership Tune-Up on Cooling System Ac operating at temp, Amp draw at 80/% on compressor Would recommend looking at the options of equipment replacement. Equipment is 25 years old and functional. A/c could last the summer. Maybe,,,

Performed maintenance check, system operating properly at this time. York package unit is leaking water into unit during cooling, unable to find reason a this time, have photos, will need to get with tech support, to get install specs on unit, and find out cause. Currently not leaking due to heating mode.

Platinum membership 2 system found gas valve failed replaced and updated tstat. System operating properly at this time.

Replace gas valve and trailer garage furnace operating properly at this time also renewed platinum plan for 5 units

Unit had fault code of high pressure fault/air flow. Found filter to be dirty, replaced. Cycled unit, readings are at proper levels, and heating properly at this time.

Found flame sensor was not operating properly took out and cleaned system working properly at this time

Found no problems system operating properly at this time.

Includes all miscellaneous materials and labor to completely install. For Heat Exchanger Only: $679.00

Adjusted blower delay from 90 to 120, furnace operating properly at this time.

Unit rollout switch was open, reset, found furnace to have flames rolling out when blower kicks on, heat exchanger is compromised, requires heat exchanger/collector box replacement, or unit replacement. Current unit is 2003 model. Heat exchanger was replaced once in 2013, part would still be under warranty, quoted repairs for labor.