Parkersburg WV Heating, AC Repair & Plumber

REPLACED HONEYWELL HOT SURFACE IGNITOR KIT * UNIVERSAL

Service Call Platinum Client- system was having intermittent issues with low heat pressure switch. Checked vent and drain to ensure they were clear. Picked up a new pressure switch cluster under warranty and changed out. System is functioning properly again. Also during investigation I found the transformer for the reme halo had failed. Discarded transformer and wired halo directly to board at R&C to apply 24v and got halo working again.

PILOT RELIGHT & CHECK OPERATION

Service No Charge: Exhaust pipe drain was plugged making the inducer struggle and trip out the pressure switch causing the system to shut down. This causes the inducer to struggle greatly and is likely why it has started leaking.Issues with heat exchanger is causing some blowback from the burner box when the system is igniting.Blower wheel is filthy and is also plugging up the evaporator and heat exchanger.

Performed Platinum Comfort Club Membership Tune-Up on Heating System: cleaned flame sensor, adjusted gas pressure to 3.41 IWC, changed 16×20×1 air filter, good amp draw on inducer motor, high amp draw on blower motor most likely due to previous lack of maintenance. no issues with operation at this time, but may have issues with blower motor in the future. combustion analysis shows safe and efficient operation with 81% fuel efficiency and acceptable carbon monoxide production.

Performed Platinum Comfort Club Membership Tune-Up on Heating System: cleaned flame sensor, adjusted gas pressure, changed filter (AA413). Good amp draw on both motors. combustion analysis shows safe and efficient operation.

Service Call Platinum Client: removed and replaced pressure switch combo low switch wasn’t staying closed causing faults. Just replaced both

Performed Platinum Comfort Club Membership Tune-Up on Heating System

Performed Platinum Comfort Club Membership Tune-Up on Heating System - performed cleaning and operational check of packaged unit. Changed Skuttle 20-20 filter. All checks good. Surge protection still in good condition.

Performed Platinum Comfort Club Membership Tune-Up on Heating System - performed cleaning and operational check of furnace. Changed Aprilaire 413 and #10 filters. Found failing capacitor and changed out part. All checks good.

Performed heating and cooling preventative maintenance

Performed heating and cooling preventative maintenance

Performed preventative maintenance on heating and cooling

Service Call Platinum Client- vent pipe was leaking water at elbow pipe connection. Cut pip and pulled out pipe. Allied primer and pipe glue to pipe and elbow. Reattached and added furnco. Informed customer to leave system off for at least 2 hours to allow the glue to cure.

Performed Platinum Comfort Club Membership Tune-Up on Heating System Changed air filter and water panel for humidifier. Tested humidifier operation. Checked combustion analysis, gas pressure, amp draws, and temperature rise. Cleaned drains and flame sensor. Added surge protector on furnace. Furnace is in good working order.

Work performed under GHAC Quality Pledge: Inspection on furnace. Operating within range: gas pressures 3.3”WC, temperature rise 42 degrees, combustion analysis 140ppm. No issues found. Operating properly

Commercial Service Fee 1809 DuPont road suite #2. Inspection on Goodman furnace: Model GMH950905DXAB Serial 0712154149 System was in need of maintenance: adjusted gas pressures down to 3.3”WC. Clean flame sensor, checked connections, drain, pressures switches and did a combustion analysis. 89ppm of carbon monoxide ( within range). Although system is operating properly, inducer motor is pulling over 10% of its rated amp draw values. Also, exhaust is leaking water from 2-3” connection. I am attaching a quote for replacement of inducer motor and repair of exhaust.

Service Call Fee: dead capacitor on inducer motor not allowing inducer motor to start.

Service Call Fee: gas valve having intermittent issues with opening. did not open the first two times the furnace called for heat, but lit the next two times. quoted price for new gas valve.

Service Call Platinum Client: bird lodged in exhaust vent not allowing for heat. removed bird and furnace operates just fine.

Performed Platinum Comfort Club Membership Tune-Up on Heating System - air handler heat pump. Cleaned and checked operation of equipment. Changed customer provided Skuttle 20-25 filter. Noticed no surge protection on equipment and recommended installation of surge protector. Also quoted for air purification system. Quoted price for both.

Performed Platinum Comfort Club Membership Tune-Up on Heating System All checks good

Performed Platinum Comfort Club Membership Tune-Up on Heating System Clean flame sensor changed filter checked gas pressures and heat rise performed combustion analysis and all levels were up to spec. All checks good. Customer upgraded to two visit maintenance.

Due to age and condition of furnaces I am highly recommending to start planning for replacement of both furnace in near future. In order to guarantee proper and safe operation.

Performed courtesy inspection on furnace. No issue found with system in heating operation. Tested furnace 3 times and no issues found with lighting or heating. Furnace lights and runs with good gas pressure and temperature rise.