Parkersburg WV Heating, AC Repair & Plumber

Cooling Maintenance check . Replaced failed single cell capacitor for fan on ac unit. Did not have filter size aa501 on van to replace. Customer is going to order more and change themselves. Spoke with customer about adding surge protection to equipment and about updating their carbon monoxide detection in the home.

Performed anniversary check on mini split. Cleaned filters and found no issues. Discussed maintenance plan renewal with customer.

AC repair visit. Customer's pressure switch was faulty. Performed air conditioning repair and replaced the pressure switch, issue appeared to be resolved at this time.

HVAC maintenance visit. Performed AC maintenance checklist, Looked over hvac equipment. Filter and water panel needed changed. Changed. Everything operating within manufacturer specifications. Recommend cozy hvac plus due to the age of equipment to check on each piece in its own operating season. Recommend air purifier to help the filter.

Air conditioning maintenance visit. Went through most of the AC maintenance checklist, but was unable to clean unit as customer didn't have a working hose bib. System checks out and all components operating properly.

Furnace repair visit. 1999 Kenmore furnace. Failed heat exchanger. Carbon Monoxide is out of range. Flames turn a dark orange from blue when the blower kicks on. Furnace is shut off for now. Scheduling future heater repair visit to address issues.

Furnace was not lighting. Inducer would run. Pressure switch is bad and needs replaced, control board and gas valve are bad and need replaced. Also noticed a lot of rust in the heat exchanger and the high limit switch is pinned so it cannot trip. Furnace is from the early 1980’s. Recommend replacement of the equipment.

owes 1998.00 will give Joe cash

Performed maintenance on equipment. Changed 14-25-1 filter and verified working status of BLU QR UV Light. Renewed comfort club membership and discussed surge protection.

Control board

Performed maintenance on equipment. Changed AA313 filter and verified working status of surge protection. Renewed comfort club membership with customer. All checks were good.

Replace existing furnace and ac

Performed cooling maintenance check on equipment. Changed AA413 filter. Installed surge protector on AC unit. All checks were good.

Customer accidentally grabbed the wrong filter. Picked up 413 and dropped off a 213 filter.

Fuse was blown again upon arrival. Intermittent low voltage issue. Shook and moved wires trying to cause the problem again. Could not recreate situation. Traced all the stat wires and ran my hand along them. Found 1 spot on the thermostat wire that was rubbing against sharp metal and was cut. Wrapped the wires individually then back together. Found no other issues. Watched furnace for 2 heating cycles and the start of a third. Operating normally.

21 yr old mobile home furnace flashes code 2 for pressure switch. Draft motor is not running properly. Checked heat exchanger and found that it is cracked. Customer is getting an estimate today 1-3 pm for new furnace.

Furnace is about 20 years old. Lots of rust on burners and inside heat exchanger. O2 is high and co is high. Co detector went off in house. Unsafe to operate. Recommend replacement of equipment.

3 smoke detectors

Cleaned and checked operation of equipment. Customer recently changed filter and I verified working status of surge protectors and REME LED. Discussed comfort club renewal with customer. All checks were good.

Furnace not working on arrival. Found fuse on board blown. Replaced tested operation. Functioning normally. Recommended the maintenance program. Customer will sign up for cozy hvac plus at a later time.

Performed heating and cooling check. Changed filters 213 and 20x25x1. Found no issues.

Goodman furnace 16 years old. Flashes code 3 for pressure switch stuck open, code 4 for pressure switch stuck closed, and code 8 which is not labeled. Main control board is bad. Unit needs to be properly grounded. Unit needs gas shut off. Potential issues with hot surface igniter, inducer motor, and pressure switch. Blower motor is going bad, making grinding noise. Recommend replacement.

Performed maintenance on furnace. Changed AA413 filter and recommended surge protector for system. All checks were good.

14 yr old Goodman furnace has a faulty control board. As soon as gas valve opens for ignition it shuts right back off and restarts heating process. No fault code appears on board. Applied voltage to gas valve to confirm valve was operational. This unit has had a lot of issues recently. I would not recommend continuing to spend money on repairs for this unit. Customer is getting an estimate today for a new unit.

Performed labor warranty check on equipment. Changed AA213 filter and installed surge protector. Mini split wheel beginning to have dirt build up and made customer aware that at some point we will probably need to tear the unit apart to clean it. Quoted and left brochure on Plasma Air for customer to look over.